Grindmaster PIC-2 Manual De Usuario

Drink Strength Adjustment for Model PIC2J & PIC3J (Refer to Figure D)

Tool required: #2 Flat Head screwdriver 

1. Dispense a drink to determine if drink is too strong, weak or if portion size is correct.
2. Turn off power to machine at power switch.
3. Drink strength and portion size controls will be

found behind the drain tray. (Refer to Figure D) For
portion size adjustment, turn dial clockwise to
increase dispense volume. To decrease volume
turn dial counterclockwise. For drink strength
adjustment turn dial clockwise to increase drink
strength. To decrease strength turn dial
counterclockwise. Turn on power to machine and
dispense a drink to determine if drink strength or
portion is acceptable. If drink strength or portion is
not acceptable, turn off power to machine and
repeat adjustment steps until desired drink strength
or portion is achieved. 

Note: Clockwise rotation will result in a stronger drink and
counterclockwise will result in a weaker drink. 
Note: Water flow rate is factory preset at approximately 
0.80 ounces per second.

* To adjust flow rate, remove left side upper panel. Use flat
head screwdriver and turn knob on respective dump valve.  
WARNING: Do not adjust flow rate above the factory setting to prevent funnel overflow.

PORTION SIZE ADJUSTMENT
TURN DIAL CLOCKWISE TO 
INCREASE  DISPENSE 
VOLUME
COUNTERCLOCKWISE TO 
DECREASE DISPENSE 
VOLUME

DRINK STRENGTH 
ADJUSTMENT
TURN DIAL CLOCKWISE TO
INCREASE DRINK STRENGTH
COUNTERCLOCKWISE TO 
DECREASE STRENGTH

CAUTION: When cleaning the unit, do not use cleansers, 

liquid bleach, powders or any other substance that contains    

chlorine. These products promote corrosion of stainless steel 
and plastic parts. Use of these products will void the warranty.

1. Empty the drip pan as needed and wash daily in a solution 

of dish detergent.

2. Rinse out the whipper chambers by placing the rinse 

switch (located on the right of the dispensing valves when 
the door is open) in the “ON” position. Dispense one to 
two cups until the water is clean. Short bursts of 
dispensing may also help clean the chambers more 
effectively. When completed, return the rinse switch to the 
“OFF” position. 

3. Remove the hoppers and refill with product.

Mixing Funnel Shroud

Mixing Funnel

Whipper Chamber

Dispense Nozzle

Whipper Blade

Whipper O-Ring

Whipper Base Seal

Motor Shaft

Whipper Base

Water Inlet Fitting

Water Inlet Pipe

Funnel O-Ring



when equipped with remote adjust knobs behind drip tray (Refer to Figure C)

1.  Dispense a drink to determine if drink is too strong or too weak.
2.  Remove drip tray.
3.  Using a flat head screwdriver, adjust individual dispense heads by rotating 

appropriate adjustment knob. Clockwise rotation will result in a stronger 
drink and counterclockwise rotation will result in a weaker drink.

4.  Dispense a drink to determine if drink strength is acceptable, 

repeat adjustment steps until desired drink strength is achieved.

NOTE: Water flow rate is factory preset at approximately 24mL (0.80 ounces)
per second.