Ricoh 1027 Guía De La Red
Monitoring and Configuring the Printer
78
2
spoolsw
Use the “spoolsw” command to view
and configure Job Spool settings.
You can only specify diprint, trap, lpr,
ipp, ftp, sftp, and smb(TCP/IP) pro-
tocol.
• The “spoolsw” command for con-
and configure Job Spool settings.
You can only specify diprint, trap, lpr,
ipp, ftp, sftp, and smb(TCP/IP) pro-
tocol.
• The “spoolsw” command for con-
figuring Job Spool settings is avail-
able only when the optional hard
disk is installed.
able only when the optional hard
disk is installed.
❖ View settings
The Job Spool setting appears.
msh> spoolsw
❖ Job Spool setting
msh> spoolsw spool {on|off}
Note
❒ Specify "on" to enable Job Spool,
or "off" to disable it.
❖ Resetting Job spool setting
msh> spoolsw clear job
{on|off}
{on|off}
• When the printer power is cut
during job spooling, this deter-
mines whether to reprint the
spooled job.
mines whether to reprint the
spooled job.
❖ Protocol configuration
m s h > s p o o l s w d i p r i n t
{on|off}
msh> spoolsw lpr {on|off}
msh> spoolsw ipp {on|off}
msh> spoolsw smb {on|off}
msh> spoolsw ftp {on|off}
msh> spoolsw sftp {on|off}
{on|off}
msh> spoolsw lpr {on|off}
msh> spoolsw ipp {on|off}
msh> spoolsw smb {on|off}
msh> spoolsw ftp {on|off}
msh> spoolsw sftp {on|off}
• You can specify the settings for
diprint, lpr, ipp, ftp, sftp, and
smb.
smb.
sprint
Use the “sprint” command to view
and configure IEEE 1394 (SCSI print)
settings.
and configure IEEE 1394 (SCSI print)
settings.
❖ View settings
IEEE 1394 (SCSI print) settings are
displayed.
displayed.
msh> sprint
❖ Bidirectional configuration for IEEE
1394 (SCSI print)
Use this setting to set IEEE 1394
(SCSI print) bidirectional.
The default is “on”.
(SCSI print) bidirectional.
The default is “on”.
msh> sprint bidi {on | off}
ssdp
Use the “ssdp” command to view and
configure SSDP settings.
configure SSDP settings.
❖ View settings
msh> ssdp
❖ Setting effective time
msh> ssdp profile {1801–
86400}
The default is 10800 seconds.
86400}
The default is 10800 seconds.
❖ Advertise packet TTL settings
msh> ssdp ttl {1–255}
The default is 4.
The default is 4.