Haier 29t7a Manual De Usuario
To assist in location possible faults use help guide below
BREAKDOWN PHENOMENON
PICTURE
SOUND
CHECKING
The aerial direction and connection
Volume、Sound mute
Ensure that the power supply is connected to
the TV set and turned on. Also ensure that the
TV set is not in "Listen Mode" or that the
brightness and contrast are not turned down.
the TV set and turned on. Also ensure that the
TV set is not in "Listen Mode" or that the
brightness and contrast are not turned down.
Adjust color control
Adjust channel again
Colour Purity fault which can be caused by moving
the TV set, placing magnets near the TV screen
or turning on/off house hold appliances such as
vacuum cleaners near the TV set. Turn the TV off with
the mains power switch for 15 minutes. When the
power is turn on again the TV set will automatically
degauss the picture. In server cases leave
the TV set turned off over night
the TV set, placing magnets near the TV screen
or turning on/off house hold appliances such as
vacuum cleaners near the TV set. Turn the TV off with
the mains power switch for 15 minutes. When the
power is turn on again the TV set will automatically
degauss the picture. In server cases leave
the TV set turned off over night
.
Picture with snow
Noise
Color Spot
Normal Volume
Scramble
Normal or Weak Volume
No Color
Normal Volume
No Picture
No Sound
No Sound
Normal
Normal
Disturb
Noise
Double or Triple Image
Note:
1.If the fault can not be repaired using the above guide consult with your local authorized service center.
2.The TV set must only be repaired by a qualified registered service person. Never attempt to remove the
back cover as the TV set has dangerous voltages in side that may cause a fatality or fire.
3. The cabinet may produce the occasional "snapping sound" This is normal and caused by the materials
in the cabinet expanding with room temperature changes.
TROUBLESHOOTING GUIDE
Electrical interference which can be caused by
cars, motorbikes etc, Fluorescent lamps and
dirty insulators on overhead power cables.
cars, motorbikes etc, Fluorescent lamps and
dirty insulators on overhead power cables.
This is called ghosting which can be minimized
with an outside aerial, and good quality cable
and terminations. Altering the aerial direction
can also minimize this effect.
with an outside aerial, and good quality cable
and terminations. Altering the aerial direction
can also minimize this effect.
17