Frigidaire gles388dsb Hoja De Datos
5
FAN BLADE
The fan blade is mounted in the rear of the unit and has a "D" shaped mounting hole. Only minimum clearance exists
between the oven back, fan blade, and fan shroud. Be careful not to bend blade when removing or installing.
between the oven back, fan blade, and fan shroud. Be careful not to bend blade when removing or installing.
Access to the fan blade is gained by removing the fan shroud, held in place by three screws, from the inside of the oven.
The fan blade is held in place with a hex nut that has left handed threads. When removing this nut, gently hold the
fan blade, and turn the nut clockwise. If one of the blades becomes deformed, it may be bent back into shape using
a flat surface as a reference.
fan blade, and turn the nut clockwise. If one of the blades becomes deformed, it may be bent back into shape using
a flat surface as a reference.
A flat washer is located on the motor shaft between the snap ring on the shaft and the fan blade.
NOTE: If the fan blade is bent and motor vibrations increase, the noise made by the fan will be greater.
MOUNTING PLATE OVEN
The fan motor on the rear of the unit is mounted to the main back (with three screws). There is a mounting plate held
in place between the main back (with 2 screws) and the rear oven wall (with 2 screws). Should it be necessary to replace
the oven cavity, you must remove the 2 screws located inside the unit at the rear of the oven cavity.
in place between the main back (with 2 screws) and the rear oven wall (with 2 screws). Should it be necessary to replace
the oven cavity, you must remove the 2 screws located inside the unit at the rear of the oven cavity.
FAN MOTOR
The 120 volt fan motor is located on the outside of the rear of the oven.
FAN RELAY
The fan motor runs continuously while in the convection mode unless the door is opened. If the fan does not operate,
check the following:
check the following:
•
Display illuminated on the electronic control.
•
Voltage output between terminals P5-7 and Neutral.
•
120 Volts available at fan motor.
•
Fan motor coil resistance 56.5 ohms ± 10%.
•
Door/light switch.
DOOR LOCK MECHANISM
The appliance is equipped with an electronic oven control and has an auto locking door latch feature. When the self
clean cycle is programmed, the door is locked by a motor operated latch system. The interior of oven does'nt need to
heat up to 500°F/260°C before the door locks. However, until the temperature inside oven reaches 500°F/260°C, the
self-clean program can be canceled and door will unlock immediately. After oven reaches temperatures over 500°F/
260°C, the door will not unlock until temperature drops below 500°F/260°C.
clean cycle is programmed, the door is locked by a motor operated latch system. The interior of oven does'nt need to
heat up to 500°F/260°C before the door locks. However, until the temperature inside oven reaches 500°F/260°C, the
self-clean program can be canceled and door will unlock immediately. After oven reaches temperatures over 500°F/
260°C, the door will not unlock until temperature drops below 500°F/260°C.