Microtek 4500t Guía De Operación
34 ArtixScan 4500t Installation and Operation Manual
English
Questions and Answers for Macintosh G3/G4
Q1: The SCSI card cannot be found by Macintosh G3/G4
A1:
Your interface card is not properly seated in the interface card slot on your Macintosh.
To fix this problem, power down your Macintosh G3/G4, remove the SCSI interface card from
Macintosh. Then reinstall it, make sure the card is seated all the way in and secured into
the card slot.
Macintosh. Then reinstall it, make sure the card is seated all the way in and secured into
the card slot.
Q2: My SCSI card is detected by Macintosh, but the scanner cannot be
found.
found.
A2:
Follow the steps below:
1 If your scanner has a SCSI terminator switch, switch it to the On position. If the
scanner doesn’t have a SCSI terminator switch, plug the SCSI terminator on the SCSI
port.
port.
2. If your scanner is chained to other SCSI device, the SCSI ID of the SCSI device should
not be set to the same ID number. By default, Microtek’s scanner SCSI ID is 6.
Q3: What’s the recommended power up sequence?
A3:
Power up your scanner first, then the computer.
Q4: I have followed the above instructions, but still cannot fix the problem.
A4:
Visit the web site of the SCSI card provider (e.g., Adaptec or AdvanSys).