Nortel 2526T Guía Del Usuario
Securing your system
39
show password aging-time day command
The
password aging-time day
command shows the configured
password aging-time.
The syntax of the command is:
show password aging-time
The following shows a sample output for this command:
2550T (config)#show password aging-time
Aging time:
100 days
Configuring the number of password logon attempts
The
telnet-access retry
command configures the number of times a
user can attempt a password:.
The syntax of the command is:
telnet-access retry <number>
where
<number>
is an integer in the range 1-100 that specifies the allowed
number of failed logon attempts. The default is 3.
If a new aging time is set from the CLI, the password aging counters are
not reset.
not reset.
Configuring the IP manager list
When enabled, the IP manager list determines which source IP addresses
are allowed access to the switch. No other source IP addresses have
access to the switch. You configure the IP manager list by using the
following commands:
are allowed access to the switch. No other source IP addresses have
access to the switch. You configure the IP manager list by using the
following commands:
•
•
•
•
•
show ipmgr command
The
show ipmgr
command displays whether Telnet, SNMP, and Web
access are enabled; whether the IP manager list is used to control access
to Telnet, SNMP, and the Web-based management system; and the current
IP manager list configuration. The syntax for the
to Telnet, SNMP, and the Web-based management system; and the current
IP manager list configuration. The syntax for the
show ipmgr
command is:
show ipmgr
Nortel Ethernet Routing Switch 2500 Series
Security — Configuration and Management
NN47215-505 (323165-B)
02.01
Standard
4.1
19 November 2007
Copyright © 2007, Nortel Networks
.