Nortel 1010 Guía Del Usuario

Chapter 5 Configuring the system 97

Nortel VPN Router Configuration — Basic Features 

 

MAC Pause (Ethernet packet flow control) section enables the Nortel VPN 
Router to automatically adjust and control the flow of incoming and/or 
outgoing packets from any standard speed LAN device. 

Check to enable MAC Pause (Frame-based flow control) on the selected 
interface port. 

When enabled, specify the appropriate Pause parameters to be set in the 
hardware. 

Specify a value for MAC Pause Ticks. 

Select a value from the Free Receive FIFO Threshold list. The default is 0. 

Select Enabled or Disabled for the 802.1Q VLAN setting. Enabling 802.1Q 
VLAN requires that you set this option to Enabled and then click OK. This 
takes you back to the System > LAN window.

Enter an identification number for a VLAN ID in the range 1 - 4094, 
inclusive. This is the VLAN identifier for the interface VLAN. The default 
value is 1.

Select Accept Untagged to accept Ingress inbound frames untagged or 
Discard Untagged to drop them.

10 Select Tagged too tag Egress (outbound) frames. Untagged is default.

11 Click Configure Subinterfaces to configure and to view existing VLAN 

subinterfaces on the selected interface.

12 Click Subinterface Statistics to view current statistical information about the 

selected VLAN subinterface. 

You configure multinetting on the LAN port using either the System > LAN 
window or on the CLI. Multinetting requires a primary interface that must be 
present before adding secondary addresses. However, in a configuration where 
both primary and secondary addresses are defined, changing the primary address 
is not possible. 

All secondary addresses must be deleted before the primary address can be 
changed.