Nortel 8800 dslam Guía De Instalación
3-1
8800-A2-GN21-20
October 1997
Initial Setup Instructions
3
Setting the IP Address and Subnet Mask on the MCC
for Remote Configuration
for Remote Configuration
You can configure the MCC and DSL cards at the CO using the console terminal.
However, if you want to perform remote card configuration from a network
management workstation by means of a telnet session, you must set the IP
address and subnet mask of the MCC card using the local terminal at the CO
before you can configure the cards remotely.
However, if you want to perform remote card configuration from a network
management workstation by means of a telnet session, you must set the IP
address and subnet mask of the MCC card using the local terminal at the CO
before you can configure the cards remotely.
This section describes how to set the IP address and subnet mask of the MCC
card. Refer to the
card. Refer to the
HotWire DSLAM for 8540 and 8546 DSL Cards User’s Guide
for detailed information on how to configure the MCC and DSL cards.