MTX txc4-1 Guía Del Usuario
MTX..COM
BI-AMP CONFIGURATION
These crossovers feature Bi-amp connections so that when used in a 3-way confi guration the
components can be wired to drive the TXC6.0 woofer and the TXC component system independently
using two amplifi ers. When using the 3-way components in the Bi-Amp confi guration you are going
to need two stereo amps or one four channel amp to run the components. You will need to remove
the Bi-amp jumpers from the input connection points of the TXC6.0 crossover. Connect the desired
amp or channels to the HF+ and HF- input. The second amplifi er, or third and fourth channels of the
4-channel amplifi er, will be connected to the LF+ and LF- input on the crossover. When the crossover
is set up in this confi guration, the fi nal load will be 4 ohms.
components can be wired to drive the TXC6.0 woofer and the TXC component system independently
using two amplifi ers. When using the 3-way components in the Bi-Amp confi guration you are going
to need two stereo amps or one four channel amp to run the components. You will need to remove
the Bi-amp jumpers from the input connection points of the TXC6.0 crossover. Connect the desired
amp or channels to the HF+ and HF- input. The second amplifi er, or third and fourth channels of the
4-channel amplifi er, will be connected to the LF+ and LF- input on the crossover. When the crossover
is set up in this confi guration, the fi nal load will be 4 ohms.
Note: It is important to make sure the gain of each amplifi er is matched. Final gain level adjustments
should be made using the crossover settings.
should be made using the crossover settings.
Note: Adding the TXC6.0 woofer to a full TXC component system can dramatically affect the balance
between your tweeter and the 0, 30, and 60 degree setting of your existing midrange. You may need
to change your midrange off-axis settings and readjust the tweeter attenuation in order to achieve
the optimum balance. See the TXC6.1, 5.1, 4.1 Owner’s Manual for instructions on how to make these
adjustments.
between your tweeter and the 0, 30, and 60 degree setting of your existing midrange. You may need
to change your midrange off-axis settings and readjust the tweeter attenuation in order to achieve
the optimum balance. See the TXC6.1, 5.1, 4.1 Owner’s Manual for instructions on how to make these
adjustments.
CROSSOVER CONNECTIONS
MTX002044 TXC6.0 Owners Manual.indd 6-7
MTX002044 TXC6.0 Owners Manual.indd 6-7
4/18/05 8:06:40 AM
4/18/05 8:06:40 AM