Rimage 7100 Guía De Referencia

2000246_B 

© 2007, Rimage Corporation 

3 

5. Raise 

the 

lift arm to the top of the shaft. 

6.  Verify that the flag is in the center of the sensor. 

 

Tip: Use a flashlight to clearly see the sensor 
and flag. 

 

 

 
 

 
 
 

 

1. Install 

the 

carousel. 

2. Install 

the 

printer cover, or close the top access cover, as necessary.  

3. Close 

the 

front door. 

4. Connect 

the power cord to the power outlet. 

5.  Power on the Producer. 

Run diagnostic test 3 – calibrate lift home. Refer to the Operator Level Diagnostic Tests document available 
at 

.  Navigate: Producer Family > Support – Your Product > Documents tab. 

 

Note: For AutoPrinter II, Navigate: Printer Family > Support – AutoEverest / AutoPrism, 4 Bin > Documents 
tab. 

 

Tip: If, when running diagnostic test 3, the discs are rubbing on the carousel or are not being picked 
properly, align the lift arm to the carousel. Refer to the Align the Lift Arm to the Carousel document available 
at 

. Navigate: Producer Family > Support – Your Product > Documents tab. 

 

Email: 

Tel: +49-(0) 6074-8521-0

• 

Unit serial number and software version. 

• 

Functional and technical description of the problem. 

• 

Exact error message received. 

Tel: North America: 800-553-8312 
Asia/Pacific, Mexico/ Latin America: 952-946-0004

 

Rimage Corporation reserves the right to make improvements to the 
equipment and software described in this document at any time without 
any prior notice. Rimage Corporation reserves the right to revise this 
publication and to make changes from time to time in the content hereof 
without obligation of Rimage Corporation to notify any person or 
organization of such revisions or changes.