Intermec cv60 Instruccion De Instalación
2
Installation Procedures
Chapter
—
10
CV60 DC-DC Converter Installation Guide
Before You Start
Equipment failure or damage will result if the
vehicle power source voltage does not fall within
the input voltage rating of the power supply
furnished to you.
vehicle power source voltage does not fall within
the input voltage rating of the power supply
furnished to you.
Power Supplies
Read the nomenclature on the power supply and verify that the
input voltage rating is correct for the vehicle you will be instal-
ling it in.
input voltage rating is correct for the vehicle you will be instal-
ling it in.
See Chapter 1 “Introduction” for identifying information.
Connect Power Input Cable
Only one of the input connectors will fit the power supply:
1
Mate the corresponding cable connector to the power supply
connector.
connector.
2
Slide the cable connector IN as far as it will go.
3
Turn the cable connector collar clockwise to secure it.
4
Clamp the ferrite beard onto the input cable near the power
supply. Make sure tabs are fully engaged.
supply. Make sure tabs are fully engaged.
5
Cut cable at the unused (2 pin end) cable connector.
6
Discard the unused connector.