Intermec 5020 Guía Del Usuario

Select Start > Settings. The Control Panel appears.

Tap the System tab.

Tap Intermec Settings.

Double-tap UDP Plus.

Make sure that the UDP Plus Activate check box is not checked.

Tap the round X button in the upper right corner of the screen. If you 
made a change, the “Save configuration changes?” prompt appears. Tap 
Yes to save the changes.

To close Intermec Settings, tap the round X button in the upper right 
corner of the screen.

Perform the steps in the section, 

Select Start > Settings. The Control Panel appears.

Tap the System tab.

Tap Intermec Settings.

Double-tap UDP Plus.

Tap UDP Plus Activate until a check appears in the check box.

Tap Controller IP. An edit box appears. Tap inside the edit box and 
type the IP address for the controller. Tap outside the edit box to close 
it.

Tap Controller Port if you need to change the port number (which 
defaults to 5555) to match the port configured for UDP Plus on the 
controller. An edit box appears. Tap inside the edit box and type the 
port number. Tap outside the edit box to close it.

Tap the round X button in the upper right corner of the screen. The 
“Save configuration changes?” prompt appears.

Tap Yes to save the changes.

To close Intermec Settings, tap the round X button in the upper right 
corner of the screen.

Perform the steps in the next section, 

Note: When you start the dcBrowser client for the first time, you will be 
prompted for an IP address and port number.