Intermec SR60 Guía De Referencia
Chapter 2 — Configuring Interface Settings
36
SR60 Scanner Programmer’s Reference Manual
Note: Each handshaking feature requires a series of bar codes in
the sequence given. That is, you must enter Programming mode
by scanning the SET bar code, scan the Step #1 bar code, scan the
Step #2 bar code, and then scan the END bar code.
the sequence given. That is, you must enter Programming mode
by scanning the SET bar code, scan the Step #1 bar code, scan the
Step #2 bar code, and then scan the END bar code.
Enable CTS/RTS Flow Control
SET-------------------------------------
Step #1
---------
Step #2
---------
END------------------------------------
Enable CTS Scan Control
SET------------------------------