Citel 3000 Guía Del Usuario
Page 20
EXTender 3000 System Administrator’s Guide (Definity)
Programming from a Terminal
Programming from a Terminal
Introduction
The Office Module can ONLY be programmed using a terminal. The Remote Module can be programmed
via a terminal or by using the phone menus.
via a terminal or by using the phone menus.
For basic Voice Extension, the following Office Module parameters require programming using a PC:
•
ISDN Parameters –SPID/DN (U interface only), TEI and Connect Rate.
Depending on your Configuration, the following Office Module parameters may require programming using
a PC:
a PC:
•
Passwords
•
COM Port – Data Rate, Parity, Data Bits, Stop Bits.
•
PPP and Bridging Parameters – (for Ethernet data only)
The COM Port settings are for the RS232 data port that is used by all data types.
Configuration Requirements
The Office Module must be connected to a PC or terminal using an RS232 serial cable, which connects to
the RS232 port on the module. Your terminal application should be configured for VT100 emulation.
the RS232 port on the module. Your terminal application should be configured for VT100 emulation.