Citel 4000 Guía De Instalación

IP Call-Suspend Setup, continued 
 
2. Press 

the 

→ key to access the parameters. 

 

 

3. Press 

the 

→ key to the Enabled parameter. Press the → key to select Yes 

4. Press 

the 

↓ and  → key to the Timeout parameter. This parameter causes the units to go into Call 

Suspend mode when no activity occurs for the set Timeout value. 
Note: Set the value between 15 and 240 minutes. 
 

5. Press 

the 

↓ and → key to the Remote Only Wakeup parameter. Setting this parameter to Yes 

enables wakeup from Call Suspend on activity (for example, when a telephone set goes off-hook or a 
key is pressed) at the Branch site only. If this parameter is set to No (disabled), incoming calls can 
also cause wakeup from Call Suspend. 

6. Press 

the 

↓and →key to the Mode parameter. Press the →key to select Lamp or Ring. 

7. Press 

the 

↓and →key to the Indicators parameter. Enter a list of monitored indicators separated by 

commas. 

8. Press 

the 

↓and →key to the ACD Tone parameter. Press the →key to select Yes or No. 

: Mode, Indicator, and ACD Tone are not supported by Norstar, Alcatel, or NEC. 

 

9. Press 

the 

←key to accept changes and go back to the Configuration Menu. 

10. Press the 

←key to the Save parameter. Press Enter to save changes to the active config (.rem) file. 

EXTender 4000 Universal Quick Installation Guide

 

22