Citel 6000 Guía De Instalación
EXTender 6000 Quick Installation Guide
27
2. Press
the
Ækey to access the parameters
3. Press
the
Æ
key to the DCE Type parameter. Press the Æ key to select the ISDN TA being used.
(See page 7
for a list of recommended devices.)
4. Press
the
È
key to the Async Rate parameter. Press the Æ key to select the rate required. This
parameter sets the asynchronous data transfer speed of the WAN port and MUST match the TA
speed setting.
Note: This Async Rate should be left at the <default> setting of 115200.
speed setting.
Note: This Async Rate should be left at the <default> setting of 115200.
5. Press
the
È
key to the ISDN Switch Type parameter. Press the Æ key to select the type of Central
Office (CO) switch being used for the ISDN connection.
Note: Leave the ISDN Switch Type at the “default” setting of National_ISDN. This setting should work
for most types of Central Office switches. If problems occur, contact the local telephone company and
inquire about the switch in use.
for most types of Central Office switches. If problems occur, contact the local telephone company and
inquire about the switch in use.
6. Press
the
È
key to the Phone Numbers menu.
The following menu appears:
Figure 16: Phone Numbers Menu
Note: Press the
Æ
key to enter the appropriate information provided by the system administrator.
• Local Dialing Num1 parameter. Enter the DN 1 number assigned to the ISDN line, which was
provided when the ISDN line was installed. Example: 2881918
• ISDN SPID 1 parameter. Enter SPID 1 assigned to the first ISDN B-channel. Example:
40328819180101
• Local Dialing Num2 parameter. Enter the DN 2 number assigned to the ISDN line.
• ISDN SPID 2 parameter. Enter SPID 2 assigned to the second ISDN B-channel.
• Dial Prefix parameter. Enter the required prefix for dialing out on this WAN port. Example: 98
• Dialback Num1 parameter. Enter the telephone number for dialing the first ISDN B-channel of the
• ISDN SPID 2 parameter. Enter SPID 2 assigned to the second ISDN B-channel.
• Dial Prefix parameter. Enter the required prefix for dialing out on this WAN port. Example: 98
• Dialback Num1 parameter. Enter the telephone number for dialing the first ISDN B-channel of the
EXTender from the PBX location where the Gateway is installed. Example: 914032881918
• Dialback Num2 parameter. Enter the telephone number for dialing the second ISDN B-channel of the
EXTender from the PBX location where the Gateway is installed.
7. Press
the
Å
key to accept changes and go back to the Configuration Menu.
8. Press
the
È
key to the Save parameter. Press Enter to save changes to the active config (.rem) file.