Citel 6000 Guía Del Usuario
PBXgateway
™
& EXTender
TM
6000 System Administrator’s Guide
55
Synchronous-Serial Device Configuration (RVP_Direct)
This section of the manual provides the necessary information to configure the PBXgateway and
EXTender 6000 for connection to a synchronous-serial device. The units are programmed at the factory
with “default” settings providing basic parameters to accommodate many network environments.
EXTender 6000 for connection to a synchronous-serial device. The units are programmed at the factory
with “default” settings providing basic parameters to accommodate many network environments.
Prerequisites for Configuration
Both units must be installed properly (see Chapter 2) and the network link between both devices must
be operational.
Basic Configuration – EXTender and PBXgateway
be operational.
Basic Configuration – EXTender and PBXgateway
You must ….……
to…………
Follow these steps…….
Set the voice compression
algorithm for all active phone
ports.
algorithm for all active phone
ports.
Provide adequate bandwidth for
all users.
all users.
Adjust the Jitter setting.
(PBXgateway Only)
(PBXgateway Only)
Match network characteristics.
Refer to page 63
Adjust the Attenuation.
(PBXgateway Only)
(PBXgateway Only)
Decrease echo.
Refer to page 63
Enable/Disable WAN ports
Enable WAN ports to connect
to network device.
to network device.
Refer to page 70
Set the Sync Rate of the
WAN port
WAN port
Match the data rate (sync rate)
of the network device.
of the network device.
Refer to page 71
Set the mode (interface type)
of the WAN
of the WAN
Match the interface type of the
network device.
network device.
Refer to page 71
Configure the Remote unit.
Set the required parameters.
Refer to page 106
Table 7:
Basic Configuration Steps