Citel 6000 Guía Del Usuario
PBXgateway
™
& EXTender
TM
6000 System Administrator’s Guide
59
IP Network Configuration (RVP_Over_IP)
MCK’s IP-based products utilize Voice over IP (VoIP) technology to deliver remote voice solutions. The
voice quality of these solutions is dependent on variables such as available bandwidth, network latency
and quality of service (QoS) initiatives, all of which are controlled by the network and internet service
providers. Because these variables are not in MCK’s control, it cannot guarantee the performance of the
user's IP-based remote voice solution.
This section of the manual provides the necessary information to configure the PBXgateway for
connection within an IP network.
Note: The units are programmed at the factory with RVP_Direct “default” settings. The “connect”
parameter (see page 106) must set to RVP_Over_IP.
Prerequisites for Configuration
Both units must be installed properly (see Chapter 3) and the network link between both devices must be
operational. The network administrator must allocate an IP address for each unit.
Basic Configuration - EXTender and PBXgateway
voice quality of these solutions is dependent on variables such as available bandwidth, network latency
and quality of service (QoS) initiatives, all of which are controlled by the network and internet service
providers. Because these variables are not in MCK’s control, it cannot guarantee the performance of the
user's IP-based remote voice solution.
This section of the manual provides the necessary information to configure the PBXgateway for
connection within an IP network.
Note: The units are programmed at the factory with RVP_Direct “default” settings. The “connect”
parameter (see page 106) must set to RVP_Over_IP.
Prerequisites for Configuration
Both units must be installed properly (see Chapter 3) and the network link between both devices must be
operational. The network administrator must allocate an IP address for each unit.
Basic Configuration - EXTender and PBXgateway
You must ….……
to…………
Follow these
steps…….
steps…….
Set IP parameters.
Allow the PBXgateway to communicate
over the IP network.
over the IP network.
Refer to page 76
Set up voice parameters
for all active phone ports,
and tune Jitter delay and
packet size.
(Gateway Only)
for all active phone ports,
and tune Jitter delay and
packet size.
(Gateway Only)
Enable each port to select compression
method and tune voice parameters to
accommodate IP network.
method and tune voice parameters to
accommodate IP network.
Refer to page 63
Disable both WAN ports.
Disable ports that are unnecessary for
RVP_IP.
RVP_IP.
Refer to page 70
Configure the Remote
unit.
unit.
Set the required IP and Connect
parameters.
parameters.
Refer to page 106
Table 11: Basic Configuration Steps