SATO MB410i Guía Del Usuario
Unit 4: Operation and Configuration
MB400i/MB410i Operator Manual
PN 9001190C
Page 4-3
SETTING THE DIP SWITCHES
Figure 4-3, Location of DIP Switch Cover
1. See USB/DIP switch cover in Figure 4-3. Orient the printer with the USB/DIP switch cover
facing you.
Figure 4-4, Printer with DIP Switch Cover Open
2. You can pry open the USB/DIP switch cover so that the DIP switches are accessible to you.
Use a small screwdriver to pry outward the small black vinyl cover labeled DSW on corner of
unit as it is shown in Figure 4-4.
unit as it is shown in Figure 4-4.
3. Look straight downward into the DIP switch compartment or panel in order to see the white
DIP switches. Next to switch number 1 is a directional arrow showing the On setting direc-
tion. Off is in the opposite direction. Figure 4-4 also shows the On arrow.
tion. Off is in the opposite direction. Figure 4-4 also shows the On arrow.
4. In order to determine how to set the DIP switches, use the table in the Enabling and Disabling
Special Functions section of the Operating Modes chapter in this manual.
5. To adjust a DIP switch, push the white switch with either the end of a paper clip or a very
small screwdriver.
RS-232C cover
Battery cover
USB/DIP switch cover
RS-232C cover
Battery cover
234
1
1
ON