IBM R30 Manual Suplementario

Message:

Hibernation error

Solution:

The system configuration changed between the time your computer

entered hibernation mode and the time it left this mode, and your computer
cannot resume normal operation.
v Restore the system configuration to what it was before your computer

entered hibernation mode.

v If the memory size has been changed, re-create the hibernation file.

Message:

Operating system not found.

Solution:

Verify the following:

v The hard disk drive is correctly installed.
v A startable diskette is in the diskette drive

If you still see the same error message, check the boot sequence using BIOS
Setup Utility.

Message:

Fan error

Solution:

Cooling fan has failed. Have the computer serviced.

Errors without codes or messages

Problem:

When I turn on the machine, nothing appears on the screen and the

machine does not beep while starting up.

Note:

If you are not sure whether you heard any beeps, turn off the
computer; then turn it on again and listen. If you are using an external
monitor, refer to External monitor problems.

Solution:

If a power-on password is set, press any key to display the

power-on password prompt, and then type the correct password and press
Enter

If the power-on password prompt does not appear, the brightness control
might be set to minimum brightness. Adjust the brightness level by pressing
Fn+Home.

If the screen still remains blank, make sure that:
v The battery is installed correctly.
v The ac adapter is connected to the computer and the power cord is plugged

into a working electrical outlet.

v The computer power is on. (Turn on the power switch again for

confirmation.)

Solving computer problems

Chapter 2. Solving computer problems