Bissell 3541 Guía Del Usuario

12

Possible Causes

Remedies

Vacuum cleaner is not plugged in

Check electrical plug

Household fuse/breaker

Check/replace fuse - 
Reset breaker button 

Motor Guard activated

Move Power Switch to OFF. Disconnect
plug from outlet. Remove Brush Cover
(See page 9). Remove visible obstructions.
Replace Brush Cover. Allow motor to cool 
for 5 minutes. Press Motor Guard button
to reset. 

Possible Causes

Remedies

Dust Bag is full

Replace with new bag

Rotating Brush Drive Belt broken

Replace Drive Belt (See page 9)

Drive Belt stretched

Reposition belt/clean brush/belt areas

off Motor Pulley Shaft

(See page 9)
If Belt is stretched, it should be replaced
(See page 9)

Rotating Floor Brush bristles worn

Replace brush (See page 9)

Rotating Floor Brush jammed

Remove brush and clean debris from 
brush ends (See page 9)

Height adjustment too high

Reset Height Adjustment

Air Passageway clogged

Remove Brush Cover. (See page 9)
Clean debris from passageway
If still clogged: Remove Vacuum Body 
from Powerfoot.
Directions: 1. Remove screw from front 

of Vacuum Body (reverse of step 3. in How 
To Use section.)
2. Gently insert blade of flathead screwdriver
underneath the plastic tab on the back of the 
Vacuum Body to lift past the raised area 
inside the rectangular opening.
3. Pull upward on Vacuum Body handle 
and lift Vacuum Body off of Powerfoot.
Remove blockage.

Possible Causes

Remedies

Vacuum Flex Hose clogged

Visually check for objects blocking
suction path and remove carefully

Possible Causes

Remedies

Dust Bag is too full

Replace with new bag

Vacuum path is blocked

Visually check hose and tools for 
obstruction. Remove Brush Cover and 
clean debris from passageway
suction path and remove carefully

Possible Causes

Remedies

Incorrect Height setting

Dial Adjustment to next highest setting