Bissell 5770 Guía Del Usuario
5
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Tool required: Phillips screwdriver
1.
Slide upper handle onto lower handle. Insert
one screw into hole marked with an arrow
and tighten until snug.
one screw into hole marked with an arrow
and tighten until snug.
2.
Attach hose by lining up the tabs on the
collar with the corresponding notches on
the back of the vacuum as shown. Turn
clockwise to lock the hose into place.
collar with the corresponding notches on
the back of the vacuum as shown. Turn
clockwise to lock the hose into place.
3.
Wrap the hose by routing it down and into
the lower hose clip then up and over the top
of the handle. Insert the hose wand fully into
the hose base.
the lower hose clip then up and over the top
of the handle. Insert the hose wand fully into
the hose base.
Note: It is important that the hose is fully
inserted into the base for the suction air to
be directed properly to the foot during floor
vacuuming.
inserted into the base for the suction air to
be directed properly to the foot during floor
vacuuming.
4.
Store TurboBrush on the front of the handle
by aligning the slot at the bottom with the
tab and snapping into place.
by aligning the slot at the bottom with the
tab and snapping into place.
5.
Place crevice tool inside telescoping extension
wand. Store tools on vacuum as shown.
wand. Store tools on vacuum as shown.
A
ssembly
CAUTION:
Do not plug in your
vacuum cleaner until
you are familiar with
all instructions and
operating procedures.
vacuum cleaner until
you are familiar with
all instructions and
operating procedures.
1
2
4
5
3
ug203-1369_5770_507.indd 5
ug203-1369_5770_507.indd 5
5/31/07 1:15:29 PM
5/31/07 1:15:29 PM