Jiffy j-1 Guía Del Usuario
J-2
1. For J-2 models, attach hose firmly with included
assembly wrench, which is magnetized and located on
the bottom of the unit (figure #1). Assemble and attach
hose hanger rod set. For J-1 models, the brass hat nozzle
should already be attached. There is no rod set or hose
attachment for J-1 models. Every Jiffy
the bottom of the unit (figure #1). Assemble and attach
hose hanger rod set. For J-1 models, the brass hat nozzle
should already be attached. There is no rod set or hose
attachment for J-1 models. Every Jiffy
®
Steamer has
been factory tested and it is not uncommon for small
amounts of water to be in the unit.
amounts of water to be in the unit.
2. Invert bottle of fresh tap or distilled water, plug into proper voltage
outlet, turn switch to lighted ON position and you will have steam
within minutes. Never use your foot to turn steamer on/off. Never substitute
the Jiffy
within minutes. Never use your foot to turn steamer on/off. Never substitute
the Jiffy
®
Steamer water bottle.
3. For easy operation, mount optional Jiffy
®
Steamboard to
door or wall to hold clothing while steaming (figure #2).
For hanging garments without optional Jiffy
For hanging garments without optional Jiffy
®
Steamboard, simply install an eye screw or nail to inside
of a doorway or directly onto a wall or you may use
steamer’s rod set as shown in figure 3. Touch material
lightly with steaming head and wrinkles will vanish
instantly. The combined touch of the steaming head and
the direct steam is very important. Some articles can be
steamed better from the underneath side. Speed and
efficiency is accomplished with a little practice. Always
steam with hose in an upright position, so any
condensation is free to flow back into
steamer. If steaming in a low position
near floor, extend hose up and out
frequently to keep clear of condensation.
DO NOT ALLOW STEAMER TO RUN
DRY.
of a doorway or directly onto a wall or you may use
steamer’s rod set as shown in figure 3. Touch material
lightly with steaming head and wrinkles will vanish
instantly. The combined touch of the steaming head and
the direct steam is very important. Some articles can be
steamed better from the underneath side. Speed and
efficiency is accomplished with a little practice. Always
steam with hose in an upright position, so any
condensation is free to flow back into
steamer. If steaming in a low position
near floor, extend hose up and out
frequently to keep clear of condensation.
DO NOT ALLOW STEAMER TO RUN
DRY.
4. Hang steam head in an upright position
in the hose hanger section when not in
use and turn switch to OFF (figure #3).
use and turn switch to OFF (figure #3).
5. Periodically, pour old water out of
steamer to avoid sediment buildup and maintain proper
water level (figure #4). Remove hard water deposits with
Jiffy
water level (figure #4). Remove hard water deposits with
Jiffy
®
Liquid Cleaner. See page 28 for complete cleaning
instructions.
NOTE: No two water supplies have the same mineral content. If your steamer begins to
cut on and off during normal use, the thermostat is indicating the heating unit needs the
sediment cleaned out.
cut on and off during normal use, the thermostat is indicating the heating unit needs the
sediment cleaned out.
Figure 1
Jiffy
®
J-1 and J-2 Model Steamer Directions
Figure 2
Figure 4
11
Figure 3
WARNING: Never operate without water. Unplug after each use.