Acer ac711 Manual De Usuario

 

 

 

 

2

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 
15 of the FCC Rules.  T hese limits are designed to provide reasonable protection against harmful interference in a 
residential installation.  This equipment generates, uses, and can radiate radio frequency energy, and, if not 
installed and used in accordance with the instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following measures: 

n Reorientate or relocate the receiving antenna; 

n Increase the separation between the equipment and receiver; 

n Connect the equipment with a power socket on a circuit different from that to which the receiver is 

connected; 

n Consult the dealer or an experienced radio/TV technician for help. 

Any changes or modifications not expressly approved by the manufacturers may void t he user’s authority to 
operate this equipment. 

 

 

A shielded-type video signal cable is required in order to meet the FCC emission limits and also 
to prevent interference to nearby radio and television reception.  It is essential t hat only the 
supplied power cord be used. 
Use only shielded cables to connect I/O devices to this equipment. 

 

For Class B Computing Devices 
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing 
Equipment Regulations.  

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel 
brouilleur du Canada. 

1. 

Place the monitor with its tube down on a stable 
surface. 

2. 

Align the four tabs of the swivel base with the 
slots in the bottom of the monitor. 

3. 

Insert the tabs into the slots of the monitor 

4. 

Now slowly slide the swivel base toward the 
front of the monitor till you hear the spring lock 
click into place.

 

 

If you need to remove the swivel base, push the spring lock and  then pull the swivel base away from the monitor. 

Special attention should be paid to the control knobs and LED indicators on the front panel 

when you place the monitor with its tube down. This will prevent damage to these control knobs and 
LED indicators from excessive pressure.