OEM iw-101 Instruccion De Instalación

IW-101

Important Information

Caution:

This is a "Common Ground" switch.

It is not intended to be used with equipment which is incapable of
operating with "common ground" connections.

Consult the owner’s manual of the equipment to be connected.

Severe circuit damage can occur to equipment not designed for
"common ground" type connections.

Wire & Wiring Notes:

A) Wiring to and from switch should be "CL-2 or CL-3" rated. Use 16 gauge or larger for runs in excess of 100 feet.

B) Strip ¼" off each wire. Ensure all strands are twisted together and inserted into respective terminals.

C) For 12 gauge and larger wire, trim some of the strands off to enable them to fit into the terminals.

D) Perform initial testing of selector at low volume level to prevent damage to equipment.

Precautionary Information Concerning Using More Than Two (2) Pairs of Speakers

Because most amplifiers are designed to operate between 4 - 8 ohms you should not configure your system to play any
more than two (2) pair of 8 ohm speakers at a time.

If you wish to wire your system to play more than two (2) pair of 8 ohm speakers simultaneously you need to install an
impedance compensating device. These are manufactured by OEM Systems:

SW-4SPKR
4 pair speaker switcher with impedance compensation

SW-8SPKR
8 pair speaker switcher with impedance compensation