Panasonic TC-P42G10 Guía Del Usuario

45

 Network Setting

 The network settings become effective when you close the menu and run “Connection test”.

Check that the network settings are as shown below, and then start “Connection test”.

Succeeded: “Connection test” succeeded

Only home network:

    Home 

network 

is 

available.

Failed:  

Check the broadband environment connection 

and settings and the network settings, and then 

perform the test again.

Test in progress

---:      Test not yet performed

*Press OK again to cancel the test.

(It takes a while to cancel the test.)

 select

 ok

 

 Select “IP setting mode” and set to “Manual”

 

 Select the item and press OK

 

  Check the specifications of the broadband router and 

enter each IP address.

(When IP automatic acquisition in DHCP can be used)

The acquired address is displayed.

 select

 ok

 

 change 

channel

 ok

or

(When DNS automatic acquisition in DHCP can be used)

The acquired address is displayed.

 select

 ok

If you are using a broadband router, IP automatic 

acquisition in DHCP can be used under normal 

circumstances. If you are not sure, check with the 

person who installed the equipment, or check the 

instructions for each device.

 

 Select “DNS setting mode” and set to “Manual”

 

 Select the item and press OK

 

  Enter each IP address as was specified by the 

provider.

 

 select

 ok

or

   Normally, select “Automatic”.

  If “Connection test” failed, set the “LAN speed setting” 

to “manual” and then select “10BASE half duplex”, 

“10BASE duplex”, “100BASE half duplex” or “100 BASE 

duplex”.

  Cannot be selected when the “LAN speed setting” is 

“Automatic”.

  Changing the settings may make it impossible to 

connect some types of equipment. 

 select

 adjust

 * Set “Clock” first. (p. 18)

 select

 ok