Billion 5100 Guía Del Usuario

Descargar
Página de 86
 
19
ENET ENCAP Gateway fields are not applicable (N/A) as the DHCP server assigns them to 
the BIPAC-5100/5100W. 
3.7.4 Private IP Addresses 
Every machine on the Internet must have a unique address. If your networks are isolated from 
the Internet, for example, only between your two branch offices, you can assign any IP 
addresses to the hosts without problems. However, the Internet Assigned Numbers Authority 
(IANA) has reserved the following three blocks of IP addresses specifically for private 
networks: 
10.0.0.0 - 10.255.255.255 
172.16.0.0 - 172.31.255.255 
192.168.0.0 - 192.168.255.255 
You can obtain your IP address from the IANA, from an ISP or it can be assigned from a 
private network. If you belong to a small organization and your Internet access is through an 
ISP, the ISP can provide you with the Internet addresses for your local networks. On the other 
hand, if you are part of a much larger organization, you should consult your network 
administrator for the appropriate IP addresses. 
3.8 Nailed-Up Connection (PPP) 
A nailed-up connection is a dial-up line where the connection is always up regardless of traffic 
demand. The BIPAC-5100/5100W does two things when you specify a nailed-up connection. 
The first is that idle timeout is disabled. The second is that the BIPAC-5100/5100W will try to 
bring up the connection when turned on and whenever the connection is down. A nailed-up 
connection can be very expensive for obvious reasons. 
Do not specify a nailed-up connection unless your telephone company offers flat-rate service 
or you need a constant connection and the cost is of no concern 
3.9 NAT 
NAT (Network Address Translation - NAT, RFC 1631) is the translation of the IP address of a 
host in a packet, for example, the source address of an outgoing packet, used within one 
network to a different IP address known within another network. 
3.10 Wizard Setup Configuration: Second Screen 
The second wizard screen varies depending on what mode and encapsulation type you use. 
All screens shown are with routing mode. Configure the fields and click Next to continue.