Billion 5100 Guía Del Usuario

 

85

I cannot access the Internet. 

1 

Make sure the BIPAC-5100/5100W is turned on and connected to the network. 

2 

If the DSL LED is off, refer to Section A.1.3. 

3 

Verify your WAN settings. 

4 

Make sure you entered the correct user name and password. 

5 

For wireless stations, check that both the BIPAC-5100/5100W and wireless station(s) 

are using the same ESSID, channel and WEP keys (if WEP encryption is activated). 

Internet connection disconnects. 

1 

Check the schedule rules. 

2 

If you use PPPoA or PPPoE encapsulation, check the idle time-out setting. 

3 

Contact your ISP. 

I cannot remotely manage the BIPAC-5100/5100W from the LAN or WAN. 

1 

Refer to the Remote Management Limitations section in the Firmware and Configuration 

File Management chapter for scenarios when remote management may not be possible.

2 

Use the BIPAC-5100/5100W’s WAN IP address when configuring from the WAN. 

Use the BIPAC-5100/5100W’s LAN IP address when configuring from the LAN. 

3 

Refer to Section A.6 for instructions on checking your LAN connection. 

Refer to Section A.7 for instructions on checking your WAN connection. 

4 

See also the Section A.4. 

I cannot connect to a remote node or ISP. 

1 

Check WAN screen to verify that the username and password are entered properly. 

2 

Verify your login name and password for the remote node. 

3 

If these steps fail, you may need to verify your login and password with your ISP.