Billion 5100s Manual De Usuario

 

11

It is highly recommended that you change the password for accessing the BIPAC 5100S. 

To change the BIPAC 5100S’s password, click Advanced Setup and then Password. The 

screen appears as shown. 

 

The following table describes the labels in this screen. 

 

 

Old Password 

Type the default password or the existing password you use to access the 

system in this field. 

New Password 

Type the new password in this field. 

Retype to Confirm 

Type the new password again in this field. 

Apply 

Click Apply to save your changes back to the BIPAC 5100S. 

Cancel 

Click Cancel to begin configuring this screen afresh. 

If you forget your password or cannot access the BIPAC 5100S, you will need to reload the 

factory-default configuration file or use the RESET button the back of the BIPAC 5100S. 

Uploading this configuration file replaces the current configuration file with the factory-default 

configuration file. This means that you will lose all configurations that you had previously and 

the password will be reset to “admin”. 

 

Step 1. Make sure the SYS LED is on (not blinking). 

Step 2. Press the RESET button for five seconds, and then release it. When the SYS LED 

begins to blink, the defaults have been restored and the BIPAC 5100S restarts.