Billion 5100s Manual De Usuario

 

68

 

The LEDs are useful aides for finding possible problem causes. 

The PWR LED on the front panel does not light up. 

1 

Make sure that the BIPAC 5100S’s power adaptor is connected to the BIPAC 5100S 

and plugged in to an appropriate power source. Use only the supplied power adaptor. 

2 

Check that the BIPAC 5100S and the power source are both turned on and the BIPAC 

5100S is receiving sufficient power. 

3 

Turn the BIPAC 5100S off and on. 

4 

If the error persists, you may have a hardware problem. In this case, you should contact 

your vendor. 

The LAN LED on the front panel does not light up. 

1 

Check the Ethernet cable connections between your BIPAC 5100S and the computer or 

hub.  

2 

Check for faulty Ethernet cables. 

3 

Make sure your computer’s Ethernet card is working properly. 

4 

If these steps fail to correct the problem, contact your local distributor for assistance. 

The DSL LED on the front panel does not light up. 

1 

Check the telephone wire and connections between the BIPAC 5100S DSL port and the 

wall jack. 

2 

Make sure that the telephone company has checked your phone line and set it up for 

DSL service.