Panasonic DBS 576 Manual Suplementario

Section 700 - Operation

Chapter 7. SLT Features

576-50-700

DBS 576HD (USA) issued September 2001

3-9

A properly equipped system supports Caller ID, a service offered by the network telephone service 

provider. The CO sends calling number information to the system after the first ring. Users with 

display telephones can see Caller ID information as incoming calls ring at their extension. They can 

also access previous calls via the Caller ID Call Log feature. The Caller ID number is recorded in 

SMDR.

With Version 5.0, the caller name (if available) can be displayed for a calls received from an 

ISDN PRI line (ISDN / PRI NI II standard only).

•

Loop-start trunk card (8) (VB-44510) with Caller ID circuit card (8) (VB-44513), Loop-start 

trunk card (4) (VB-44514) with Caller ID circuit card (4) (VB-44515), ISDN (PRI = VB-44540, 

BRI = VB-44530).

•

FF2-0: Caller ID

•

FF2-0: Caller ID Ring Control

•

FF3-0: Call Duration Display

•

FF1-0-01: Alpha Tagging (Name/No. Display)

•

ISDN (PRI/BRI - T Point) can get calling party information.

•

Caller ID service must be ordered from the local telephone operating company or the 

interexchange carrier.

•

Caller ID data is usually sent between the first and the second rings of the incoming trunk call. 

The trunk may be programmed to immediately ring at the station or wait until after the Caller ID 

digits are received before ringing at the station. If the trunk is programmed to ring immediately, 

the Caller ID digits will not display until after they are received and processed.

•

Caller ID numbers may be denied from being sent for some callers (private). Some long distance 

carriers may not provide Caller ID data (out of area).

•

Prior to Version 3.5, Caller ID supported only the number format. Version 3.5 and higher 

supports selection of the number or name.

•

In Version 3.5, Caller ID displays the highest ringing priority call (call queued to ring at the 

target extension immediately after the present call terminates).

If the received Caller ID phone number matches any number in the System Speed Dials (SSD000-

SSD199), then the associated System Speed Dial name can be displayed as the Caller ID information. 

Alternatively, the DID name may be displayed instead.
In Version 3.5 and higher, Caller ID information will be shown on the second line of the LCD display 

when an incoming call rings a display phone with a conversation already in progress. Second 

incoming calls include extension Camp-on, extension Call Wait, queued DIL, both Appearance and 

non-Appearance calls (CO, MCO, virtual or DN, recall, BLF).