Panasonic DBS 576 Manual Suplementario
7-4
DBS 576HD (USA) issued September 2001
576-50-700
Chapter 7. SLT Features
Section 700 - Operation
To cancel an Absence Message
Related Programming
•
FF1 (System): Extension Class of Service Setting
•
FF3 (Extension): Extension Class of Service Assignment
•
FF8 (Maintenance): Absence Messages
Considerations
•
Calling parties without a display get a busy signal, rather than the Absence Message.
•
Regardless of setting an Absence Message on a DID/DIL extension, DID/DIL calls are routed
according to the trunk ringing setting.
•
An absence message may also be cancelled by dialing 7**. This cancels Do Not Disturb and Call
Forwarding-All Calls as well.
Account Codes
Description
You can assign account codes to clients to facilitate billing and to track call dates and times, numbers
called, and outside line numbers used. This information is printed for each account on the System
Message Detail Recording (SMDR) record.
In addition verified account codes may be used to change the TRS level to allow calls to numbers
In addition verified account codes may be used to change the TRS level to allow calls to numbers
otherwise restricted.
Account codes may be either forced or unforced (voluntary) and either verified or unverified.
This feature works with Station Message Detail Recording (SMDR). Before making an outgoing call,
Account codes may be either forced or unforced (voluntary) and either verified or unverified.
This feature works with Station Message Detail Recording (SMDR). Before making an outgoing call,
a station user can silently enter an accounting or client billing code. Then later, the SMDR reports will
show the Code dialed for each call, and even sort the report by these Codes.
There are two different types of account codes: Non-Verified and Verified Account Codes. Prior to
There are two different types of account codes: Non-Verified and Verified Account Codes. Prior to
Version 3.6, the maximum amount of account code numbers for both types could range from 1-10
digits. Beginning with Version 3.6, a second mode has been added that allows the user to set the
maximum amount of account code numbers from 1-4 digits. An account code error will occur when
more than the maximum number of digits are entered.
Non-Verified Account Codes
Non-Verified Codes aren’t checked by the system for validity. Depending on the setting, the user can
enter anything from 1-4 digits or 1-10 digits. Individual phones can be programmed to accept forced
Account Codes (the user must enter a code for every call) or voluntary Account Codes (the user can
enter a code, but doesn’t have to, for each call).
Action
Result
1. Lift the handset.
Intercom dial tone
2. Enter the Absence Message code (default = 729).
3. Flash the hookswitch.
4. Replace the handset.