Panasonic KX-TG2313 Guía Del Usuario

“No link to base. Move 
closer to base, try 
again.” is displayed and an 
alarm tone sounds.

• You are too far from the base unit. Walk 

closer to the base unit.

• Confirm the base unit’s AC adaptor is 

plugged in.

• Raise the base unit antenna.
• If the above remedies do not solve the 

problem, the handset may have lost 
communication with the base unit. Register 
the handset again (p. 40).

The handset and/or base unit 
does not work.

• Check the settings (p. 8–10).
• Check whether the dialing mode setting is 

correct (p. 13).

• Fully charge the battery (p. 9).
• Clean the charge contacts and charge again 

(p. 10).

• Check battery installation (p. 9).
• Unplug the base unit’s AC adaptor to reset it. 

Plug in, and try again.

• Re-install the battery (p. 9) and fully charge it.

Static, sound cuts in/out, 
fades. Interference from other 
electrical units.

• Move the handset and base unit away from 

other electrical appliances (p. 3).

• Walk closer to the base unit.
• Raise the base unit antenna.

The handset does not ring.

• The ringer volume is turned off. Set to high, 

medium, or low (p. 15).

The handset display is blank.

• If the handset display is blank, fully charge 

the battery (p. 9).

You cannot program any 
function items.

• Programming is not possible while the 

handset and/or base unit is being used.

• Do not pause for over 60 seconds while 

programming.

• Walk closer to the base unit.

While programming or 
searching, the handset starts 
to ring and the program/
search stops.

• A call is coming in. To answer the call, press 

[C] or [s]. Start again from the beginning 
after hanging up.

PQQX13982YA.book  Page 47  Friday, January 23, 2004  10:02 AM