Wolf 315i Instruccion De Instalación
5
Dimensions in parentheses are in
millimeters unless otherwise specified.
millimeters unless otherwise specified.
U N D E R C O U N T E R
I N S T A L L A T I O N I N S T R U C T I O N S
U N PA C K I N G
A N D
M OV I N G
Uncrate the unit and remove its wood base.
Remove all packing materials and tape.
Remove all packing materials and tape.
IMPORTANT NOTE: Do not discard the
kickplate, anti-tip bracket, hardware and the
shipping bolts that hold the wood to the
bottom of the unit (leveling legs). These items
will be needed for the installation.
kickplate, anti-tip bracket, hardware and the
shipping bolts that hold the wood to the
bottom of the unit (leveling legs). These items
will be needed for the installation.
Roller-assembly wine shelves should be
removed to reduce weight and prevent them
from rolling (Models UC-24B and UC-24C). To
remove, pull the shelf out to its full extension,
gently and evenly lift up on both sides of the
front of the shelf and remove. Reverse the
procedure to reinstall the shelf.
removed to reduce weight and prevent them
from rolling (Models UC-24B and UC-24C). To
remove, pull the shelf out to its full extension,
gently and evenly lift up on both sides of the
front of the shelf and remove. Reverse the
procedure to reinstall the shelf.
Use an appliance dolly to move the Under-
counter unit. Position the dolly at the back of
the unit to prevent damage to finished
surfaces.
counter unit. Position the dolly at the back of
the unit to prevent damage to finished
surfaces.
Before moving the Undercounter unit into
position, protect any finished flooring
with appropriate materials and secure the
door closed.
position, protect any finished flooring
with appropriate materials and secure the
door closed.
P O S I T I O N
T H E U N I T
IMPORTANT NOTE: If the Undercounter unit
has been laid on its back or side, you must
allow the unit to stand upright for a minimum
of 24 hours before connecting power.
has been laid on its back or side, you must
allow the unit to stand upright for a minimum
of 24 hours before connecting power.
Plug the power supply cord into the 15 amp
grounded electrical outlet. With power applied
to the appliance, check for lighting and cooling
before going any further. Once you are satis-
fied that the unit is operating properly, shut off
power to the electrical outlet at the circuit
breaker and proceed.
grounded electrical outlet. With power applied
to the appliance, check for lighting and cooling
before going any further. Once you are satis-
fied that the unit is operating properly, shut off
power to the electrical outlet at the circuit
breaker and proceed.
Pre-level the unit before sliding it into position.
Leveling cannot be completed with the unit
pushed back in the installation opening.
Leveling cannot be completed with the unit
pushed back in the installation opening.
The Undercounter unit provides the best
access to its contents when the front surface of
the door panel extends out from surrounding
cabinets approximately
access to its contents when the front surface of
the door panel extends out from surrounding
cabinets approximately
1
/
4
" (6).
IMPORTANT NOTE: The floor under the
Undercounter unit must be at the same level
as the surrounding finished floor to allow for
removal of the unit for servicing.
Undercounter unit must be at the same level
as the surrounding finished floor to allow for
removal of the unit for servicing.
Shut off the power to the electrical outlet.