3com 4200G PWR Guía De Referencia
3Com Switch 4200G Family
21
Command Reference
info-center logbuffer
Use the
info-center logbuffer
command to enable information output to the log buffer through the
specified channel (you can also set the size of the log buffer in this command).
System view
info-center loghost
Use the
info-center loghost
command to enable information output to a log host through the specified
channel.
System view
info-center loghost source
Use the
info-center loghost source
command to configure the source interface through which log
information is sent to the log host.
System view
info-center monitor channel
Use the
info-center monitor channel
command to enable information output to terminals through a
specified channel.
System view
info-center snmp channel
Use the
info-center snmp channel
command to enable information output to the SNMP through a
specified channel.
System view
info-center source
Use the
info-center source
command to add a record (that is, an information source) to an information
channel.
System view
info-center synchronous
Use the
info-center synchronous
command to enable synchronous terminal output.
System view
Use the
info-center synchronous
command to enable synchronous terminal output, so that if system
information (such as log information) is output when the user is inputting, the command prompt and input
information are echoed after the output (note that, the command prompt is echoed in command edit state
but is not echoed in interactive state).
information are echoed after the output (note that, the command prompt is echoed in command edit state
but is not echoed in interactive state).
info-center timestamp
Use the
info-center timestamp
command to set the format of time stamp included in the log/trap/debug
information or specify not to include time stamp in the information.
System view
info-center timestamp loghost
Use the
info-center timestamp loghost
command to set the format of time stamp to be sent to log host.
System view
info-center trapbuffer
Use the
info-center trapbuffer
command to enable information output to the trap buffer.
System view
instance
Use the
instance
command to map specified VLANs to a specified spanning tree instance.
MST Region view
interface
Use the command
interface
command to enter Ethernet port view. To configure parameters for a port, you
must enter the port view first.
System view
interface VLAN-interface
Use the
interface vlan-interface
command to create a management VLAN interface and enter
management VLAN interface view.
System view
ip address
Use the
ip address
command to assign an IP address (and mask) to a management VLAN interface.
VLAN Interface view
ip address bootp-alloc
Use the
ip address bootp-alloc
command to configure VLAN interface to obtain IP address using
BOOTP.
VLAN Interface view