3com 5500-ei pwr Guía De Instalación Rápida
38
C
HAPTER
3: S
ETTING
U
P
FOR
M
ANAGEMENT
The initial set up of your Switch is now complete and the Switch is ready
for you to set up your chosen management method. See
for you to set up your chosen management method. See
.
If you do not intend to use the command line interface via the console
port to manage the Switch, you can disconnect the serial cable and close
the terminal emulator software.
port to manage the Switch, you can disconnect the serial cable and close
the terminal emulator software.
Connecting to a Front
Panel Port
To set up your Switch manually you can, alternatively, make a connection
to a front panel port. To do this you will need an IP address, refer to
to a front panel port. To do this you will need an IP address, refer to
for more
information.
The procedure described in this section assumes the unit has been
powered up in standalone mode.
powered up in standalone mode.
Pre-requisites
■
A workstation running a suitable operating system — refer to
.
■
A Network Interface Card (NIC).
■
A Category 5 twisted pair Ethernet cable with RJ-45 connectors at
both ends.
both ends.
■
A suitable Web browser — refer to
.
■
Existing IP address of the Switch.
■
You need to have the following so that you can manually set up the
Switch with IP information:
Switch with IP information:
■
IP address
■
subnet mask
■
default gateway
■
management VLAN ID, normally set to the default value (1)
DUA1715-0AAA02.book Page 38 Wednesday, March 23, 2005 11:17 AM