3com 5500-ei pwr Guía De Instalación Rápida
4
C
REATING
AN
XRN S
TACKING
F
ABRIC
This chapter contains the information you need to create an XRN
Stacking Fabric. It covers the following topics:
Stacking Fabric. It covers the following topics:
■
■
■
The procedure for creating a Fabric with the Switch 5500-SI units is the
same procedure as that for creating a Fabric with the Switch 5500-EI
units.
same procedure as that for creating a Fabric with the Switch 5500-EI
units.
How To
Interconnect Units
Interconnect Units
Up to eight 3Com Switch 5500 units can be interconnected to create an
XRN Stacking Fabric and then treated as a single manageable unit with
one IP address.
XRN Stacking Fabric and then treated as a single manageable unit with
one IP address.
You can interconnect your Switches to create an XRN Fabric using a
standard 1000 Mbps Ethernet connection.
standard 1000 Mbps Ethernet connection.
variants of the Switch 5500 family, how they physically interconnect and
the level of XRN support offered by the Fabric.
the level of XRN support offered by the Fabric.
It is not possible to create a Fabric by interconnecting a 3Com Switch
5500 with any other 3Com device or mix Enhanced Image (EI) Switch
5500 units with Standard Image (SI) units.
5500 with any other 3Com device or mix Enhanced Image (EI) Switch
5500 units with Standard Image (SI) units.
This section assumes you have either set up your units for management
as detailed in
as detailed in
or that you are
using a console cable connected to the console port to set up and
allocate IP addresses and so on.
allocate IP addresses and so on.
3Com recommends that you do not physically connect the cables on your
Fabric ports until you have carried out the initial configuration of the
Fabric ports as detailed below.
Fabric ports until you have carried out the initial configuration of the
Fabric ports as detailed below.
DUA1715-0AAA02.book Page 57 Wednesday, March 23, 2005 11:17 AM