3com 5500-ei pwr Instruccion De Instalación

 

2-3 

Figure 2-4 Set port parameters 

 

 

3)  Turn on the switch. You will be prompted to press the Enter key if the switch successfully 

completes POST (power-on self test). The prompt appears after you press the Enter key. 

4)  You can then configure the switch or check the information about the switch by executing the 

corresponding commands. You can also acquire help by typing the ? character. Refer to related 

parts in this manual for information about the commands used for configuring the switch.  

Table 2-2 Common configuration of console port login 

Baud rate 

Optional 

The default baud rate is 19,200 bps. 

Check mode 

Optional 

By default, the check mode of the console port is set to 
“none”, which means no check bit. 

Stop bits 

Optional 

The default stop bits of a console port is 1. 

Console port 
configuration 

Data bits 

Optional 

The default data bits of a console port is 8. 

AUX user interface 
configuration 

Configure the 
command level 
available to the 
users logging in to 
the AUX user 
interface 

Optional 

By default, commands of level 3 are available to the 
users logging in to the AUX user interface. 

Terminal 
configuration 

Make terminal 
services available 

Optional 

By default, terminal services are available in all user 
interfaces