3com 5500-ei pwr Instruccion De Instalación

 

1-28 

Follow these steps to specify whether the link connected to a port is point-to-point link in Ethernet port 
view: 

Enter system view 

— 

Enter Ethernet port view 

 interface-type 

interface-number 

— 

Specify whether the link 
connected to a port is a 
point-to-point link 

stp point-to-point 

{ force-true 

| force-false | auto } 

Required 
The auto keyword is adopted 
by default. 

 

z

 

If you configure the link connected to a port in an aggregation group as a point-to-point link, the 
configuration will be synchronized to the rest ports in the same aggregation group. 

z

 

If an auto-negotiating port operates in full duplex mode after negotiation, you can configure the link 
of the port as a point-to-point link. 

 

After you configure the link of a port as a point-to-point link, the configuration applies to all the MSTIs the 
port belongs to. If the actual physical link of a port is not a point-to-point link and you forcibly configure 
the link as a point-to-point link, loops may occur temporarily. 

# Configure the link connected to Ethernet 1/0/1 as a point-to-point link. 

1)  Perform this configuration in system view 

<Sysname> system-view 

[Sysname] stp interface Ethernet 1/0/1 point-to-point force-true 

2)  Perform this configuration in Ethernet port view 

<Sysname> system-view 

[Sysname] interface Ethernet 1/0/1 

[Sysname-Ethernet1/0/1] stp point-to-point force-true 

Follow these steps to enable MSTP in system view: 

Enter system view 

— 

Enable MSTP 

Required 
MSTP is enabled globally by default.