3com 5500-ei pwr Instruccion De Instalación
3-7
Follow these steps to configure RIP to filter incoming/outgoing routes:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
filter-policy { acl-number | ip-prefix
ip-prefix-name [ gateway
ip-prefix-name ] | route-policy
route-policy-name } import
ip-prefix-name [ gateway
ip-prefix-name ] | route-policy
route-policy-name } import
Configure RIP to filter
incoming routes
incoming routes
filter-policy gateway ip-prefix-name
import
import
Required
By default, RIP does not
filter any incoming route.
filter any incoming route.
The gateway keyword is
used to filter the incoming
routes advertised from a
specified address.
used to filter the incoming
routes advertised from a
specified address.
filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ protocol
[ process-id ] ]
ip-prefix-name } export [ protocol
[ process-id ] ]
Configure RIP to filter
outgoing routes
outgoing routes
filter-policy route-policy
route-policy-name export
route-policy-name export
Required
By default, RIP does not
filter any outgoing route.
filter any outgoing route.
z
The filter-policy import command filters the RIP routes received from neighbors, and the routes
being filtered out will neither be added to the routing table nor be advertised to any neighbors.
z
The filter-policy export command filters all the routes to be advertised, including the routes
redistributed with the import-route command and routes learned from neighbors.
z
You can also use the filter-policy export command to filter outgoing routes redistributed from a
specified routing protocol.
Setting RIP preference
Follow these steps to set RIP preference:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Set the RIP preference
preference value
Required
100 by default
Enabling load sharing among RIP interfaces
Follow these steps to enable load sharing among RIP interfaces: