3com 5500-ei pwr Instruccion De Instalación

 

4-13 

Optional 

Configuring the Maximum Number of OSPF 
ECMP Routes 

Optional 

Configuring OSPF to Redistribute External 
Routes 

Optional 

Configuring OSPF Timers 

Optional 

Configuring the LSA transmission delay 

Optional 

Configuring the SPF Calculation Interval 

Optional 

Disabling OSPF Packet Transmission on an 
Interface 

Optional 

Configuring OSPF Authentication 

Optional 

Configuring the MTU Field in DD Packets 

Optional 

Enabling OSPF Logging of Neighbor State 
Changes 

Optional 

Configuring OSPF Network Management 

Optional 

 

Before you can configure other OSPF features, you must first enable OSPF and specify the interface 

and area ID. 

Before configuring OSPF, perform the following tasks:  

z 

Configuring the link layer protocol 

z 

Configuring the network layer addresses of interfaces so that the adjacent nodes are reachable to 

each other at the network layer 

Basic OSPF configuration includes: 

z 

Configuring router ID 

To ensure stable OSPF operation, you should determine the division of router IDs and manually 

configure them when implementing network planning. When you configure router IDs manually, make 

sure each router ID is uniquely used by one router in the AS. A common practice is to set the IP address 

of an interface on the router to the router ID. 

z 

Enabling OSPF 

The switches support multiple OSPF processes. To enable multiple OSPF processes on a router, you 

need to specify different process IDs. OSPF process ID is only locally significant; it does not affect the