3com 5500-ei pwr Instruccion De Instalación

 

20 

Host A 

User 1 

Host A is connected to Ethernet 1/0/1 on Switch B. 

Host B 

User 2 

Host B is connected to Ethernet 1/0/2 on Switch B. 

 

In this configuration example, you need to configure the ports that connect Switch A and Switch B to 

each other as hybrid ports. The following text describes the configuration details. You can also configure 

these ports as trunk ports. The configuration procedure is omitted here. For details, see 

Configure a multicast VLAN, so that users in VLAN 2 and VLAN 3 can receive multicast streams 

through the multicast VLAN. 

Figure 6-4 Network diagram for multicast VLAN configuration 

WorkStation

SwitchA

SwitchB

Vlan-int20

168.10.1.1

Eth1/0/1

Eth1/0/10

Vla

n2

Vlan3

Eth1/0/10

Vlan10

Eth

1/0

/1

Eth1/0

/2

HostA

HostB

Vlan-int10

168.10.2.1

 

 

The following configuration is based on the prerequisite that the devices are properly connected and all 

the required IP addresses are already configured. 

1)  Configure Switch A: 

# Set the interface IP address of VLAN 20 to 168.10.1.1 and enable PIM DM on the VLAN interface. 

<SwitchA> system-view 

[SwitchA] multicast routing-enable 

[SwitchA] vlan 20 

[SwitchA–vlan20]port Ethernet 1/0/1 

[SwitchA-vlan20] quit 

[SwitchA] interface Vlan-interface 20 

[SwitchA-Vlan-interface20] ip address 168.10.1.1 255.255.255.0 

[SwitchA-Vlan-interface20] pim dm 

[SwitchA-Vlan-interface20] quit 

# Configure VLAN 10. 

[SwitchA] vlan 10 

[SwitchA-vlan10] quit 

# Define Ethernet 1/0/10 as a hybrid port, add the port to VLAN 10, and configure the port to forward 

tagged packets for VLAN 10. 

[SwitchA] interface Ethernet 1/0/10 

[SwitchA-Ethernet1/0/10] port link-type hybrid