3com 5500-ei pwr Instruccion De Instalación

 

1-17 

In system 
view 

dot1x supp-proxy-check 
{ logoff | trap } [ interface 
interface-list ] 

interface interface-type 
interface-number 

dot1x supp-proxy-check 
{ logoff | trap } 

Enable proxy 
checking for a 
port/specified 
ports 

In port view 

quit 

Required 

By default, the 802.1x proxy 
checking is disabled on a port. 

 

  Note: 

z 

The proxy checking function needs the cooperation of H3C's 802.1x client (iNode) program. 

z 

The proxy checking function depends on the online user handshaking function. To enable the 

proxy detecting function, you need to enable the online user handshaking function first. 

z 

The configuration listed in the above table takes effect only when it is performed on CAMS as well 

as on the switch. In addition, the client version checking function needs to be enabled on the switch 

too (by using the dot1x version-check command).  

 

Follow these steps to configure client version checking: 

Enter system view 

—

 

In system 
view 

dot1x version-check [ interface 
interface-list ] 

interface interface-type 
interface-number 

Enable 
802.1x client 
version 
checking 

In port 
view 

Required 

By default, 802.1x client version 
checking is disabled on a port. 

Set the maximum number 
of retires to send version 
checking request packets  

dot1x retry-version-max 
max-retry-version-value 

Optional 

By default, the maximum number 
of retires to send version checking 
request packets is 3. 

Set the client version 
checking period timer 

dot1x timer ver-period 
ver-period-value 

Optional 

By default, the timer is set to 30 
seconds. 

 

  Note: 

As for the dot1x version-user command, if you execute it in system view without specifying the 

interface-list argument, the command applies to all ports. You can also execute this command in port 

view. In this case, this command applies to the current port only and the interface-list argument is not 

needed.