3com 5500-ei pwr Instruccion De Instalación

 

2-11 

creating a new RADIUS scheme, you should configure the IP address and UDP port number of each 

RADIUS server you want to use in this scheme. These RADIUS servers fall into two types: 

authentication/authorization, and accounting. And for each type of server, you can configure two 

servers in a RADIUS scheme: primary server and secondary server. A RADIUS scheme has some 

parameters such as IP addresses of the primary and secondary servers, shared keys, and types of the 

RADIUS servers. 

In an actual network environment, you can configure the above parameters as required. But you should 

configure at least one authentication/authorization server and one accounting server, and you should 

keep the RADIUS server port settings on the switch consistent with those on the RADIUS servers. 

 

Actually, the RADIUS service configuration only defines the parameters for information exchange 

between switch and RADIUS server. To make these parameters take effect, you must reference the 

RADIUS scheme configured with these parameters in an ISP domain view (refer to 

). 

 

The RADIUS protocol configuration is performed on a RADIUS scheme basis. You should first create a 

RADIUS scheme and enter its view before performing other RADIUS protocol configurations. 

Follow these steps to create a RADIUS scheme: 

Enter system view 

— 

Enable RADIUS 
authentication port 

Optional 

By default, RADIUS authentication port 
is enabled. 

Create a RADIUS 
scheme and enter its 
view 

radius scheme 
radius-scheme-name 

Required 

By default, a RADIUS scheme named 
"system" has already been created in 
the system. 

 

A RADIUS scheme can be referenced by multiple ISP domains simultaneously. 

 

Follow these steps to configure RADIUS authentication/authorization servers: 

Enter system view 

—