3com 5500-ei pwr Instruccion De Instalación
1-28
Enabling the Burst Function
Refer to section
for information about the burst function.
Configuration prerequisites
You have determined that the burst function is required.
Configuration procedure
Follow these steps to enable the burst function:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable the burst function
burst-mode enable
Required
By default, the burst
function is disabled.
function is disabled.
With the XRN function enabled, do not enable the burst function. Otherwise, packets may
be forwarded improperly. Refer to the XRN Fabric part for the detailed information about
XRN.
Configuring Traffic Mirroring
Refer to section
for information about traffic mirroring.
Configuration prerequisites
z
The ACL rules for traffic classification have been defined. Refer to the ACL module of
this manual for information about defining ACL rules.
z
The source mirroring ports and mirroring direction have been determined.
z
The destination mirroring port has been determined.
Configuration procedure
Follow these steps to configure traffic mirroring:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
interface-number
—