3com 5500-ei pwr Instruccion De Instalación

 

2-3 

You can use the following commands to enable the two switches. 

Follow these steps to enable debugging and terminal display for a specific module: 

Enable system debugging for 
specific module 

debugging module-name 
[ debugging-option ] 

Required 

Disabled for all modules by 
default. 

Enable terminal display for 
debugging 

Required 

Disabled by default. 

 

The output of debugging information affects the system operation. Disable all debugging after you finish 

the system debugging. 

 

Display all enabled debugging 
on the specified device 

display debugging [ fabric | unit unit-id ] 
[ interface interface-type interface-number ] 
[ module-name ] 

Display all enabled debugging 
in the Fabric by module 

display debugging fabric by-module 

Available in any 
view. 

 

When an Ethernet switch is in trouble, you may need to view a lot of operating information to locate the 

problem. Each functional module has its corresponding operating information display command(s). You 

can use the command here to display the current operating information about the modules in the 

system for troubleshooting your system. 

Display the current 
operation information 
about the modules in 
the system. 

You can use this command in any view.

You should execute this command twice 
to find the difference between the two 
executing results, thus helping locate 
the problem.