3com 5500-ei pwr Guía De Referencia

 

1-7 

 

The VLAN configured as a control VLAN for sending or receiving flush messages must exist. You 

cannot directly remove the control VLAN. When a dynamic VLAN is configured as a control VLAN for 

the smart link group, this VLAN will become a static VLAN, and related prompt information is displayed. 

 

# Enable Ethernet 1/0/4 to process flush messages received from control VLAN 1.  

<Sysname> system-view 

System View: return to User View with Ctrl+Z. 

[Sysname] interface Ethernet 1/0/4 

[Sysname-Ethernet1/0/4] smart-link flush enable control-vlan 1 

# Enable Ethernet 1/0/5 through Ethernet 1/0/10 to process flush messages received from control 

VLAN 1.  

<Sysname> system-view 

System View: return to User View with Ctrl+Z. 

[Sysname] smart-link flush enable control-vlan 1 port Ethernet 1/0/5 to Ethernet 1/0/10 

smart-link group group-id 

undo smart-link group group-id 

System view 

group-id: Smart link group ID, in the range of 1 to 24.  

Use the smart-link group command to create a smart link group and enter smart link group view. If the 

specified smart link group exists, this command leads you into smart link group view directly. 

Use the undo smart-link group command to remove the specified smart link group.  

After creating a smart link group, you must configure member ports for this smart link group.  

Related commands: port smart-link group, link-aggregation group, port.