3com 5500-ei pwr Guía De Referencia

 

3-16 

 

 

Interface view 

None 

Use the rip split-horizon command to enable the split horizon function. 

Use the undo rip split-horizon command to disable the split horizon function. 

By default, the split horizon function is enabled. 

The split horizon function disables an interface from sending routes received from the interface to 
prevent routing loops between adjacent routers. Therefore, normally, split horizon is necessary for 
avoiding routing loops. Only in some special cases the split horizon function needs to be disabled to 
ensure the correct execution of the protocol. So, disable the split horizon function only when necessary. 

# Disable the split horizon function on the interface VLAN-interface 10. 

<Sysname> system-view 

System View: return to User View with Ctrl+Z.  

[Sysname] interface Vlan-interface 10 

[Sysname-Vlan-interface10] undo rip split-horizon 

 { 1 | 2 [ broadcast | multicast ] } 

 

Interface view 

: Specifies the version of RIP running on an interface as RIP-1. 

: Specifies the version of RIP running on an interface as RIP-2. 

: Sends RIP-2 packets in the broadcast mode. 

: Sends RIP-2 packets in the multicast mode. 

Use the rip version command to specify the version of RIP running on an interface.