3com 5500-ei pwr Guía De Referencia

 

4-5 

: Default type of external routes redistributed by OSPF. The value of this argument is 1 or 2. 

Use the default command to configure the default parameters for redistributed routes, including cost, 
interval, limit, tag, and type. 

Use the undo default cost command to restore the default. 

By default, the cost, interval, limit, tag, and type are 1, 1, 1000, 1, and 2, respectively. 

When OSPF redistributes external routes and propagates them in the entire autonomous system 

z

 

The cost of external routes can influence route selection and calculation. 

z

 

The performance of the device will be degraded significantly if OSPF redistributes routes 
frequently. 

z

 

The performance will also be degraded significantly if OSPF redistributes a large number of routes 
at one time. 

Therefore, it is necessary to reasonably set the default cost of redistributed routes, the default interval 
for redistributing routes, and the limit of routes that can be redistributed at one time. 

# Set the default cost, interval, limit, tag, and type of redistributed routes to 10, 20 seconds, 300, 15, 
and 1, respectively. 

<Sysname> system-view 

System View: return to User View with Ctrl+Z.  

[Sysname] ospf 1  

[Sysname-ospf-1] default cost 10 interval 20 limit 300 tag 15 type 1 

 

 value 

 

OSPF area view 

: Cost of the default route, in the range of 0 to 16777214. 

Use the default-cost command to configure the cost of the default route advertised by OSPF to a Stub 
area or NSSA.  

Use the undo default-cost command to restore the default. 

By default, the cost of the default route advertised by OSPF to a Stub area or NSSA is 1. 

This command only applies to an ABR in a Stub area or NSSA. 

To configure a Stub area, you need to use the stub and default-cost commands.