3com 5500-ei pwr Guía De Referencia

 

3-10 

System view 

None 

Use the pim command to enter PIM view so that you can configure PIM parameters globally. Note that 

this command is not used to enable PIM.  

Use the undo pim command to clear PIM configurations made in PIM view.  

# Enter PIM view. 

<Sysname> system-view 

System View: return to User View with Ctrl+Z. 

[Sysname] multicast routing-enable 

[Sysname] pim 

[Sysname-pim] 

pim bsr-boundary 

undo pim bsr-boundary 

Interface view 

None 

Use the pim bsr-boundary command to configure the current interface as the BSR service boundary, 

namely, the PIM-SM domain border.  

Use the undo pim bsr-boundary command to remove the configured PIM-SM domain border. 

By default, no PIM-SM domain border is configured on the switch. 

After you use this command to set a PIM-SM domain border on an interface, no bootstrap message can 

cross this border in either direction. However, the other PIM protocol packets can pass the border. With 

this configuration, you can divide a PIM-SM network into regions with different BSRs.  

Note that this command is not used to set up a multicast boundary.  

Related commands: c-bsr. 

# Configure a PIM domain border on VLAN-interface 10. 

<Sysname> system-view